SMR Gearbox Set up
Satisfactory overall performance is dependent upon suitable set up. lubrication and servicing. therefore it is crucial that the directions inside the installation and servicing leaflet. provided with every gearbox. are followed thoroughly. several of the essential aspects of belt and torque-arm set up are listed below.
one. Install pulley on gearbox input shaft as near to the reducer feasible, and mount reducer on driven shaft as near to bearing as practical. failure to accomplish this will likely result in extra loads within the input shaft bearings and output bearings and could bring about their premature failure.
2. Install motor and wedge belt drive together with the belt pull at roughly 90° to your center line among driven and input shafts. this will permit tensioning in the wedge belt drive using the torque arm which need to ideally be in tension. if output hub runs anti-clockwise. torque arm ought to be positioned the proper.
3. lnstall torque-arm fulcrum on the rigid help to ensure that the torque-arm will likely be at approximately correct angles for the center line with the driven shaft along with the torque arm case bolt. make sure there is sufficient take up from the turnbuckle for belt stress 
adjustment.
Keep near.
Bell drive may very well be found in any handy postion. if the torque arm is to be made use of to tighten the belts, the drive needs to be at about tight angle to your line amongst the input and output shafts.
Bell drive could possibly be located to your proper if desired.
If output hub rotates clock-wise. place belt drive and torque arm in opposite direction to that shown in the illustration.
Torque arm and belt take up.
Torque arm may very well be mounted to your proper if wanted.
